55% Off

The RMM4A is a 1RU rack mount carriage with a built-in power supply. The assembly accepts up to four mini modules, such as Video Modulators, Video or Audio Switching Modules, etc. The power supply features a universal input voltage...

1310/1550nm, FC/APC Connectors The FOC Series of optical couplers are used to split 1310 & 1550 nm light sources, with minimal loss, from one to up to eight fibers. The couplers are 19 inch rack mountable and have FC/APC connectors for superior...

The R. L. Drake DAD860 and DAD860A are high quality, low noise, frequency agile, digital to analog decoders designed for receiving digital signals from off-air or CATV channels. Output of the DAD860 is baseband NTSC video and stereo audio. The DAD860A,...

SW-PS-18 Power Supply Output: 18V - 1.66A For I.T.E. use only.

The Blonder Tongue HDDM-RP-2 is a Rack Mount Panel for 2 HDDM Units. The HDDM is a low cost, professional video decoder that can decode a single IP transport stream, off-air digital 8VSB channel, or a program from a clear QAM source. The unit...

BFP19, Blank Front Panel Black BFP19-2B: 19" X 3.5" (2 rack units high) BFP19-3B: 19" X 5.25" (3 rack units high)

RR-6/8RX Universal 19 inch Satellite Receiver Rack. Holds 6 or 8 Satellite Receivers (Model Dependent).   Mounting Instructions 1. Bend appropriate locking tabs up on bottom (A) and top (B) receiver trays using flat screwdriver. 2. Bend up...

The NPS Series are 60V AC power supplies designed for network powered equipment such as line extender amplifiers, interdiction and addressable taps. the NPS60-3 and 6 provide a 60 VAC output in 3 different amperage models. All models are housed in a...

The R.L. Drake MM806 is a professional quality agile television demodulator with video and audio metering that demodulates any VHF, UHF, or CATV channel (54 - 806 MHz). One MM806 may be added to a headend installation with the combined headend output...

The LE Series includes professional quality, line equalizers, designed to compensate for cable tilt. These equalizers restore proper balance to large distribution networks by attenuating the low frequencies while passing the high frequencies through with...

The TLS series of trunk line splitters are available as single port directional coupler models with values of 8, 12 and 16 dB.  All TLS series housings have 5/8-24 entry fittings on all ports and are made with a corrosion resistant material.

AQT (ATSC/QAMTransoder) accepts one input in 8VSB (digital Off-air) or QAN (digital cable) format, and delivers one output in QAM format in the 54-864 MHZ range. AQT can be utilized in a remote headend to "regenerate" a clean QAM channel from...